Skip to content
SolarRates.pk

Guide

How Many Units Does Solar Produce per Day in Pakistan? 1 kW to 10 kW, City by City and Month by Month

How many units 1 kW of solar makes per day in Pakistan, what 3, 5, 10 and 12 kW systems produce per day and per month, how output changes from June to December in Lahore, Islamabad, Karachi, Multan, Peshawar, Faisalabad and Quetta, and how to tell if your own system is underperforming.

Ahsan Sajjad · Published 9 November 2026

Quick answer: in Pakistan, 1 kW of solar panels makes about 3.6 units (kWh) a day on average across the year, after real-world losses. Multiply by your system size for a daily figure. To size a system from your bill, use the solar calculator.

"1 kW solar kitne unit banata hai?" and "10 kW solar system per day kitne unit?" are two of the most common questions people ask before buying solar, and two of the most common complaints after. Installers quote round numbers, inverter apps show numbers that swing from season to season, and neighbours compare readings that aren't comparable.

This guide gives honest figures. It explains where the average comes from, how much each common system size makes per day and per month, how output changes month by month in seven cities using NASA satellite data, and how to check whether your own system is doing what it should.

What a "unit" is

A unit on your electricity bill is one kilowatt-hour (kWh). A 1,000 watt load running for one hour uses one unit. A 1.5-ton inverter AC drawing about 1,200 watts for five hours uses about 6 units. Solar output is counted the same way, so solar units and bill units can be compared directly.

How much does 1 kW of solar produce per day?

The SolarRate.pk calculator and system pages use 3.6 units per kW per day as the yearly average for Pakistan. That figure already allows for normal losses: heat, dust, wiring, inverter conversion and the fact that panels are rarely at the perfect angle.

Where it comes from: most of Pakistan gets roughly 5 to 6.5 "peak sun hours" a day on a tilted panel over the year, according to NASA's long-term data. A peak sun hour is one hour of full-strength sunlight. Real systems turn only part of that into usable units, because panels lose output in heat (and Pakistani rooftops get very hot), glass gathers dust, and the inverter and cables waste a little. In this guide we use a conversion factor of 0.72, which is a conservative, typical figure for a hot, dusty climate. For Lahore, Multan and Islamabad that gives about 3.7 units per kW per day, close to the site's 3.6 average.

So 1 kW of panels typically gives:

  • On an average day across the year: about 3.6 units.
  • On a clear day in April or May in Punjab: close to 5 units.
  • On an average December or January day in Punjab or KP: about 2.5 to 3 units, and much less in thick fog.

How many units per day for common system sizes

Multiply your system's size in kW by 3.6 for an average daily figure. Monthly figures below use the same maths as our system price pages.

These are yearly averages. A summer month can be well above them and a winter month well below. If your bill is mostly summer AC load, size from your summer units, not the yearly average. Our guide on how much solar you need from your electricity bill walks through that.

How many units does one solar panel make?

Divide the panel's wattage by 1,000 to get kW, then multiply by 3.6. A 585 W panel, the size our system pages assume, is 0.585 kW, so it makes roughly 2 units a day on average, more in spring and less in winter. A 10 kW system is about 18 × 585 W panels, and it's the total kW that matters, not the number of panels.

"Ek plate kitne unit banati hai?" has no single answer beyond that, because the same panel gives different output on a hot, dusty Multan roof in June and a clean, cool Islamabad roof in March.

Month by month, city by city

NASA's POWER project publishes long-term monthly averages of sunlight on a tilted surface from 25 years of satellite data (2001–2025). We took the figure for a panel tilted about 15 degrees less than the city's latitude, which is close to how many rooftop frames in Pakistan are actually set, and multiplied it by our 0.72 conversion factor. The results below are units per kW per day. Multiply by your system size.

They're averages over a wide area, not a measurement of your roof, so treat them as a guide.

Lahore: January 2.5, February 3.3, March 4.1, April 4.7, May 4.9, June 4.4, July 3.6, August 3.7, September 3.9, October 3.7, November 3.0, December 2.5. Yearly average about 3.7.

Islamabad and Rawalpindi: January 2.7, February 2.9, March 3.7, April 4.4, May 4.9, June 4.8, July 4.0, August 3.8, September 4.1, October 3.9, November 3.1, December 2.7. Yearly average about 3.7.

Faisalabad: January 2.3, February 3.1, March 3.9, April 4.6, May 4.8, June 4.2, July 3.6, August 3.6, September 3.8, October 3.4, November 2.6, December 2.3. Yearly average about 3.5.

Multan: January 2.6, February 3.3, March 4.0, April 4.6, May 4.7, June 4.4, July 3.8, August 3.8, September 3.9, October 3.5, November 2.8, December 2.6. Yearly average about 3.7.

Peshawar: January 2.9, February 3.1, March 3.8, April 4.6, May 5.2, June 5.4, July 4.9, August 4.6, September 4.6, October 4.3, November 3.3, December 2.9. Yearly average about 4.1.

Karachi: January 3.5, February 4.1, March 4.7, April 4.9, May 4.8, June 4.3, July 3.4, August 3.5, September 4.1, October 4.2, November 3.6, December 3.3. Yearly average about 4.0.

Quetta: January 3.4, February 3.7, March 4.6, April 5.1, May 5.5, June 5.8, July 5.4, August 5.3, September 5.2, October 4.7, November 3.9, December 3.5. Yearly average about 4.7.

What the numbers show

The best months are April and May, not June and July. In Punjab and Karachi the monsoon brings cloud and humidity from July to September, so output falls even though the days are long. Many people expect their best readings in peak summer and are surprised when July is lower than April.

December and January are the weakest months in the north. In Lahore, Faisalabad and Multan an average December day gives roughly half of a May day. Fog and smog make some days far worse. Our guide to solar in winter and smog covers why and what to do.

Karachi is the steadiest. Its winters are sunny, so the gap between the best and worst month is much smaller than in Punjab. Its weak months are July and August, when monsoon cloud sits over the coast.

Quetta and Balochistan get the most sun. Clear, dry air gives the highest figures in the country, and the highest in summer.

A 10 kW example in Lahore: about 49 units a day in May (10 × 4.9), about 37 in July and about 25 in December. Across a year it works out close to the site's average of 1,080 units a month.

Why your system may produce less than these figures

If your readings are clearly below the month's figure for your city, check these before blaming the panels.

  1. No export, full battery. On a hybrid system without a green (net) meter, many inverters only produce what the house is using once the battery is full. The panels aren't weak; the inverter is holding them back. This is the most common reason for "low" readings in Pakistan.
  2. Dust. Pakistani rooftops get dusty fast. Research in Lahore found a flat panel lost about a quarter of its output after 100 days without cleaning. Clean with plain water and a soft brush in the morning or evening.
  3. Shade. A water tank, a neighbour's new floor, a tree or a parapet wall shading even part of one panel can pull down a whole string. Winter shadows are longer than summer ones.
  4. Facing and tilt. South-facing panels at a moderate tilt do best. East-west layouts or nearly flat frames lose output, especially in winter.
  5. Heat. Panels lose a little efficiency for every degree they heat up. In June a rooftop panel can be far hotter than the air. Raised frames with airflow underneath help, which is one reason an elevated structure can be worth it.
  6. Inverter clipping. If the panel array is much larger than the inverter, the inverter caps output at midday on the best days.
  7. Faulty or underrated panels. Only after ruling out the above, compare strings in the inverter app. If two similar strings face the same way and one reads much lower, look for a loose connector or a bad panel, and see our guide on how to check original solar panels.

How to check your own output properly

  • Use monthly totals, not single days. One cloudy day says nothing. Compare a full month with the figure above for that month.
  • Compare like with like. Compare this April with last April, not April with December.
  • Divide by kW. Take the month's total units, divide by the number of days and by your panel kW. If you get within about 15% of your city's figure for that month, your system is doing fine.
  • Check the meter too. Your inverter app shows what the panels produced. Your bill shows what you imported and, with a green meter, what you exported. They measure different things.

What this means when you buy

When an installer promises a number, ask what it's based on: yearly average, summer peak or a clear test day. A quote that says a 10 kW system will make "60 units a day" is describing the best days of spring, not your average.

Under net billing, extra units sent to the grid earn only about Rs 8.13 each, so a system much bigger than your use mainly makes cheap exports. Size from your own bill, then compare itemised quotes with Check my quote, which lines each item up against today's market prices. You can see today's estimated system costs on the system price pages, current panel prices on the panel price page, and how your bill is built up with the LESCO bill calculator or IESCO bill calculator.

Common questions

1 kW solar kitne unit banata hai? About 3.6 units a day on average across the year, roughly 100 to 110 units a month. More in spring, less in winter.

5 kW solar system per day kitne unit banata hai? Around 18 units a day on average (5 × 3.6), roughly 24 on a good spring day in Punjab and 12 to 13 on an average December day. About 540 units a month across the year.

10 kW solar system per day kitne unit? About 36 units a day on average, roughly 49 in May and 25 in December in Lahore. About 1,080 units a month across the year.

Ek solar plate kitne unit banati hai? A 585 W panel makes about 2 units a day on average. Larger panels make proportionally more.

Garmiyon mein solar zyada unit kyun nahi bana raha? In June and July, heat lowers panel efficiency, and from July the monsoon brings cloud and humidity. April and May are usually the best months.

Kya cloudy din mein solar unit banata hai? Yes, from diffuse light, but much less. A heavily overcast or foggy day may give a small fraction of a clear day.

Kya mera inverter app sahi units dikha raha hai? Usually it's close, but it shows production, not what you used or exported. Check your bill or green meter for imports and exports.

اس گائیڈ کی قیمتیں ہماری ٹریک کردہ ڈیلر لسٹنگز سے خود اپڈیٹ ہوتی ہیں (آخری تازگی 17 نومبر 2026)۔ اشارہ جاتی مارکیٹ رینجز ہیں، کوٹ نہیں۔Prices update automatically from dealer listings we track (last refreshed 17 November 2026). Indicative ranges, not quotes.

Sources

  • NASA POWER climatology (CERES SYN1deg, monthly averages January 2001 – December 2025): solar irradiance on a surface tilted at latitude minus 15 degrees, for Lahore, Islamabad, Faisalabad, Multan, Peshawar, Karachi and Quetta, accessed 9 November 2026 through the POWER Climatology API: power.larc.nasa.gov. Units per kW are our own calculation: NASA's monthly kWh/m² per day multiplied by a 0.72 conversion factor, rounded to one decimal.
  • Ullah, Imran, Maqsood and Butt, "Investigation of optimal tilt angles and effects of soiling on PV energy production in Pakistan", Renewable Energy 139 (2019) 830–843: DOI.

Satellite averages describe a wide area over many years. Your roof's shade, tilt, dust and heat change the result, so treat these figures as a guide and trust a full month of your own readings.

More guides